Suzuki 2006 SX4 Service Manual page 252

1D-21 Engine Mechanical:
3) Apply sealant "A" and "B" to specific area as shown
in figure.
"A": Sealant 99000–31260 (SUZUKI Bond
No.1217G)
"B": Water tight sealant 99000–31140 (SUZUKI
Bond No.1207B)
Sealant amount for timing chain cover
"a": 3 mm (0.12 in.)
"b": 2 mm (0.08 in.)
"c": 4 mm (0.16 in.)
"d": 16 mm (0.63 in.)
"e": 14 mm (0.55 in.)
"f": 65 mm (2.56 in.)
"g": 73 mm (2.87 in.)
1. Timing chain cover
2. Cylinder head
3. Cylinder head gasket
4. Cylinder block
I7RW01140045-01
5. Rub into
6. Jig
[C]: View C
4) Apply engine oil to oil seal lip, then install timing
chain cover (1). Tighten bolts and nut to specified
torque.
NOTE
Before installing timing chain cover, check
that pin is securely fitted.
Tightening torque
Timing chain cover bolt and nut (a): 11 N·m (1.1
kgf-m, 8.0 lb-ft)
5) Install belt idler pulley (1). Tighten nut to specified
torque.
Tightening torque
Idler pulley nut (a): 42 N·m (4.2 kgf-m, 30.5 lb-ft)
6) Install belt tensioner (2). Tighten bolts to specified
torque.
Tightening torque
Generator belt tensioner bolt (b): 25 N·m (2.5
kgf-m, 18.5 lb-ft)
7) Install water pump pulley (3).
I2RH01140057-01
I2RH01140058-01