Oil Pump Removal And Installation - Suzuki 2006 SX4 Service Manual

1E-9 Engine Lubrication System:

Oil Pump Removal and Installation

CAUTION
!
Don't remove sprocket and inner rotor from
oil pump, otherwise damage of oil pump
center shaft and abnormal operation of oil
pump could result.
Removal
1) Disconnect negative (–) cable at battery.
2) Drain engine oil.
3) Remove oil pan and oil pump strainer.
Refer to "Oil Pan and Oil Pump Strainer Removal
and Installation".
4) Remove baffle plate from lower crank case (1).
5) Remove oil pump chain guide.
6) Remove oil pump sprocket cover (1).
7) Remove oil pump (2) with sprocket from lower crank
case (1).
Installation
1) Install oil pump (2) and baffle plate to lower crank
case (1) and tighten bolts to specified torque.
NOTE
When installing oil pump, be careful not to
allow pins to fall off.
Tightening torque
Oil pump mounting bolt (M8 bolt) (a): 25 N·m (
2.5 kgf-m, 18.0 lb-ft)
Baffle plate bolt (M6 bolt): 11 N·m (1.1 kgf-m, 8.0
lb-ft)
S6RW0C1506005
2) Install oil pump chain guide (1), and tighten bolts to
specified torque.
Tightening torque
Oil pump chain guide nut (a): 11 N·m (1.1 kgf-m,
8.0 lb-ft)
1
I7RW01150012-01
3) Install oil pump sprocket cover (1), and tighten bolts
to specified torque.
Tightening torque
Oil pump sprocket cover bolt (a): 11 N·m (1.1
kgf-m, 8.0 lb-ft)
I2RH01150016-01
4) Install oil pan and oil pump strainer.
Refer to "Oil Pan and Oil Pump Strainer Removal
and Installation".
5) Refill engine with engine oil referring to "Engine Oil
and Filter Change".
6) Connect negative cable at battery.
7) After completing installation, check oil pressure by
running engine. Refer to "Oil Pressure Check".
I2RH01150017-01
I5JB0A152011-01
(a)
1
(a)
I7RW01150013-01