Suzuki 2006 SX4 Service Manual page 1063

7) Remove passenger air bag (inflator) module (1) from
its facing cover (2).
WARNING
!
• When carrying a live air bag (inflator)
module, make sure the bag opening is
pointed away from you.
Never carry air bag (inflator) module by
wires or connector on the side of the
module. In case of an accidental
deployment, the bag will then deploy with
minimal chance of injury.
• The live passenger air bag (inflator)
module must be kept with its bag (trim
cover) facing up while being stored or left
standing. This is necessary so that a free
space is provided to allow the air bag to
expand in the unlikely event of accidental
deployment.
• Observe "Precautions on Handling and
Storage of Air Bag System Components"
for handling and storing it.
Otherwise, personal injury may result.
Installation
1) Install passenger air bag (inflator) module to its
facing cover (2).
CAUTION
!
Confirm claw (1) of passenger air bag
(inflator) module hangs in its facing cover (2).
1
2) Connect passenger air bag (inflator) module
1
3) Install passenger air bag (inflator) module with its
2
I5RW0A820069-01
4) Install glove box.
5) Install center ventilation louver with garnish referring
6) Enable air bag system. Refer to "Enabling Air Bag
2
I5RW0A820070-01
connector (1) securely as shown in figure.
a) Connect connector.
b) Lock connector with lock button (2).
facing cover (3) to instrument panel at specified
torque as shown.
Tightening torque
Passenger air bag (inflator) module attaching
bolt (a): 23 N·m (2.3 kgf-m, 17.0 lb-ft)
b)
2
a)
(a)
"A"
(a)
to "Center Ventilation Louver Removal and
Installation in Section 7A".
System".
Air Bag System: 8B-98
1
3
"A"
"A"
I7RW01821034-01