Scan Tool Data - Suzuki 2006 SX4 Service Manual

Scan Tool Data

Scan tool data
Ignition switch ON after
Accel pedal Pos
warmed up engine
Engine speed At engine idle speed
2WD/4WD switch selected to 2WD position
2WD/4WD switch selected to AUTO position
2WD/4WD switch selected to LOCK position
4WD mode ABS operating
Ignition switch ON and engine stop
Stability control operating
ESP® operating
4WD current Engine running
Battery voltage At engine idle speed
Coupling temp Engine running
Wheel speed (F) Vehicle stop
Wheel speed (R) Vehicle stop
F-R Wheel speed
Vehicle stop
Diff
Ignition switch ON and 2WD/4WD switch selected to
4WD duty
2WD position
Scan Tool Data Definitions
Accel pedal Pos (Accelerator pedal position) (%)
Accelerator pedal opening ratio detected by signal on
CAN communication line fed from ECM.
Engine Speed (RPM)
This parameter indicates engine revolution calculated by
4WD control module.
4WD mode (2WD / AUTO / LOCK / ABS mode / Yaw
cont / ESP® req)
This parameter indicates 4WD mode according to 2WD/
4WD switch signal status detected by 4WD control
module.
4WD current (A)
This parameter indicates input current of coupling
assembly.
Battery voltage (V)
This parameter indicates battery voltage detected by
4WD control module.
Vehicle condition
Accelerator pedal released
Accelerator pedal depressed
fully
Coupling temp (°C, °F)
Coupling temperature detected by coupling air
temperature sensor installed in coupling assembly.
Wheel speed (F), Wheel speed (R) (km/h, mph)
Wheel speed is an ABS / ESP® control module internal
parameter. It is computed by reference pulses from the
wheel speed sensor.
F-R Wheel speed diff (Front-rear wheel speed
differential) (rpm)
This parameter indicates rotation difference between
front wheel and rear wheel detected by 4WD control
module.
4WD duty (%)
This parameter indicates operation rate of coupling
assembly.
Differential:
S6RW0C3204009
Normal condition / reference
values
0 – 5%
90 – 100%
Engine idle speed is display
2WD
AUTO
LOCK
ABS mode
Relay off
Yaw cont
ESP® mode
0 – 200 mA
10 – 14 V
–40 °C – 100 °C (–40 °F – 212 °F)
0 km/h, 0 MPH
0 km/h, 0 MPH
0 rpm
0%
3B-13