Dtc Table - Suzuki 2006 SX4 Service Manual

5A-20 Automatic Transmission/Transaxle:

DTC Table

NOTE
• There are two types of OBD system depending on the vehicle specification. For identification, refer
to "Precaution on On-Board Diagnostic (OBD) System in Section 1A".
• With the CAN communication OBD generic scan tool, DTC No. with delta ( ) mark in the following
table can not be read.
• A: Driving cycles when MIL lighting and storing DTC in TCM memory for Euro OBD model.
• B: Driving cycles when transmission warning light lighting and storing DTC in TCM memory for non-
Euro-OBD model.
• 1 driving cycle: MIL or transmission warning light lights up when DTC is detected during 1 driving
cycle.
• 2 driving cycles: MIL or transmission warning light lights up when the same DTC is detected also in
the next driving cycle after DTC is detected and stored temporarily in the first driving cycle.
• Driving cycle with (*): MIL or transmission warning light does not light up but TCM detects and
stores DTC.
DTC No. Detecting item
Control Module Programming
P0602
Error
Transmission Range Sensor
P0705 Circuit Malfunction (P R N D L
Input)
Transmission Range Sensor
P0707
Circuit Low
Transmission Fluid
P0711 Temperature Sensor "A"
Circuit Range/Performance
Transmission Fluid
P0712 Temperature Sensor "A"
Circuit Low
Transmission Fluid
P0713 Temperature Sensor "A"
Circuit High
Input Speed Sensor "A" Circuit
P0717
No Signal
Output Speed Sensor Circuit
P0722
No Signal
Torque Converter Clutch
P0741 Circuit Performance or Stuck
Off
Torque Converter Clutch
P0742
Circuit Stuck On
Shift Solenoid "A"
P0751
Performance or Stuck Off
P0752 Shift Solenoid "A" Stuck On
Detecting condition
(DTC will set when detecting:)
Data programming error
Multiple signals are inputted simultaneously from
transmission range sensor for 10 seconds or
more.
Transmission range sensor signal (P, R, N, D, 2,
or L) is not inputted for more than 30 seconds
when vehicle speed is higher than 30 km/h (19
mile/h).
Transmission fluid temperature is no change and
less than 20 °C (68 °F) while vehicle is running at
40 km/h (25 mile/h) or more for 10 minutes or
more.
Transmission fluid temperature sensor signal
voltage is less than specified value for more than
5 minutes while engine is running.
Transmission fluid temperature sensor signal
voltage is higher than specified value for 12
minutes while vehicle is running.
Pulse signals of input shaft speed sensor are not
input although pulse signals of output shaft speed
sensor are input while vehicle is running.
Pulse signals of output shaft speed sensor are
not input although pulse signals of input shaft
speed sensor are input while vehicle is running.
Difference between engine speed and input shaft
speed is larger than specification while TCC
solenoid valve is turned ON.
Difference between engine speed and input shaft
speed is smaller than specification while TCC
solenoid valve is turned OFF.
Actual gear position is different from commanded
gear position of TCM (Shift solenoid valve – A
does not turn ON).
Actual gear position is different from commanded
gear position of TCM (Shift solenoid valve – A
does not turn OFF).
S6RW0C5104004
A B
— —
1 driving 1 driving
cycle cycle
2 driving 2 driving
cycles cycles
2 driving 2 driving
cycles cycles*
1 driving 1 driving
cycle cycle
1 driving 1 driving
cycle cycle
1 driving 1 driving
cycle cycle
1 driving 1 driving
cycle cycle
2 driving 2 driving
cycles cycles*
2 driving 2 driving
cycles cycles*
2 driving 2 driving
cycles cycles*
2 driving 2 driving
cycles cycles*