Suzuki 2006 SX4 Service Manual page 649

Connector "C06"
Terminal Wire color
C06-1 BLK Ground for TCM
LT GRN/ Ground for pressure control
C06-2
BLK solenoid valve
C06-3 —
Output for pressure control
C06-4 GRY
solenoid valve
Output for TCC pressure
C06-5 WHT/BLU
control solenoid valve
C06-6 YEL/BLK Main power source
CAN communication line
C06-7 WHT
(active low signal)
C06-8 —
C06-9 —
C06-10 —
Signal for transmission fluid
C06-11 LT GRN
temperature sensor
Ground for transmission
C06-12 ORN
fluid temperature sensor
C06-13 —
C06-14 —
Shift solenoid valve – B
C06-15 BLK/YEL
(No. 2)
Shift solenoid valve – A
C06-16 BRN
(No. 1)
CAN communication line
C06-17 RED
(active high signal)
C06-18 —
C06-19 —
C06-20 —
C06-21 —
C06-22 —
C06-23 BLK Ground for TCM
C06-24 WHT/RED Power source for back-up
Standard
Circuit
voltage
0 – 1 V
0.6 – 1.0 V Ignition switch is at ON position.
— —
* 0 – 1 V
↑↓
10 – 14 V
("Reference
waveform
No. 1: ")
* 0 – 1 V
↑↓
10 – 14 V
("Reference
waveform
No. 2: ")
10 – 14 V
* 0.5 – 2.5 V
("Reference
waveform
No. 3: ")
— —
— —
— —
2.9 – 3.1 V
0.3 – 0.5 V
0 – 1 V
— —
— —
10 – 14 V
0 – 1 V
* 2.5 – 4.5 V
("Reference
waveform
No. 3: ")
— —
— —
— —
— —
— —
0 – 1 V
10 – 14 V
Automatic Transmission/Transaxle:
Condition
Ignition switch is at ON position.
—
Engine is running at idle speed.
(Output signal is duty pulse. Duty ratio varies
depending on throttle valve opening.)
Vehicle is running.
(Sensor signal is pulse. Pulse frequency varies
depending on vehicle condition.)
Ignition switch is at ON position.
Ignition switch is at ON position.
(CAN communication line signal is pulse. Pulse
signal frequency varies depending on engine
condition.)
—
—
—
Ignition switch is at ON position and transmission
fluid temperature is 20 °C (68 °F).
Ignition switch is at ON position and transmission
fluid temperature is 100 °C (212 °F).
Ignition switch is at ON position.
—
—
Ignition switch is at ON position and select lever is
at other than "P", "R" or "N" range.
Ignition switch is at ON position and select lever is
all ranges.
Ignition switch is at ON position.
(CAN communication line signal is pulse. Pulse
signal frequency varies depending on engine
condition.)
—
—
—
—
—
Ignition switch is at ON position.
Ignition switch is at ON position.
5A-61