Rear Wheel Hub Assembly Removal And Installation - Suzuki 2006 SX4 Service Manual

Rear Wheel Hub Assembly Removal and
Installation
Removal
1) Hoist vehicle and remove rear wheel.
2) Remove rear drive shaft (4WD model) referring to
"Rear Drive Shaft Assembly Removal and
Installation in Section 3A".
3) Remove rear brake caliper assembly and rear brake
disc referring to "Rear Brake Disc Removal and
Installation in Section 4C".
4) Disconnect wheel speed sensor (1).
5) Remove brake dust cover (2) and rear wheel hub
assembly (3) from rear axle.
[A]
2
3
[B]
[A]: 4WD model
[B]: 2WD model
S6RW0C2306013
1
3
1
I7RW01230014-01
6) If necessary, remove wheel stud bolts (1) with
copper hammer or hydraulic press.
CAUTION
!
Never remove bolt unless replacement is
necessary.
Be sure to use a new bolt for replacement.
Installation
1) Insert wheel stud bolt (1) in hub hole. Rotate wheel
stud bolt slowly to assure that serrations are aligned
with those made by original bolt.
1
2) Install rear brake dust cover (1), rear wheel hub
assembly (2) and then tighten new rear wheel hub
mounting bolts to specified torque.
CAUTION
!
Use new rear wheel hub mounting bolts.
Tightening torque
Rear wheel hub mounting bolt (a): 73 N·m (7.3
kgf-m, 53.0 lb-ft)
Rear Suspension: 2C-8
1
I5JB0A220016-01
I5JB0A220017-01