Evaporator Inspection; Evaporator Temperature Sensor Removal And Installation - Suzuki 2006 SX4 Service Manual

7B-27 Air Conditioning System: Manual Type
Installation
Reverse removal procedure noting the following
instructions.
• Replenish specified amount of compressor oil to
compressor suction side referring to "Replenishing
Compressor Oil" in "Operation Procedure for
Refrigerant Charge".
• Install the padding (1) to the installation hole
uniformly.
• Evacuate and charge the A/C system referring to
"Evacuation" and "Charge" in "Operation Procedure
for Refrigerant Charge".
• Refill cooling system with coolant referring to "Cooling
System Flush and Refill in Section 1F".
• Adjust control cables referring to "HVAC Control Unit
Removal and Installation in Section 7A". (vehicle with
manual type A/C)

Evaporator Inspection

Check the followings.
• Clog of A/C evaporator fins.
If any clogs are found, A/C evaporator fins should be
washed with water, and then should be dried with
compressed air.
• A/C evaporator fins for leakage and breakage.
If any defects are found, repair or replace A/C
evaporator.
• A/C evaporator fittings for leakage.
If any defects are found, repair or replace A/C
evaporator.
1
I5RW0A721025-02
S6RW0C7216009
Evaporator Temperature Sensor Removal and
Installation
Removal
1) Remove HVAC unit from vehicle body referring to
"HVAC Unit Removal and Installation".
2) Remove evaporator temperature sensor (1) from
evaporator by (2) disassembling HVAC unit.
1
Installation
Reverse the removal procedure noting the following
instruction.
• Install evaporator temperature sensor (1) onto
evaporator (2) as shown.
LH steering vehicle
2
4
3
RH steering vehicle
1
5
6
3. 138 ± 5 mm (3.3 ± 0.2 in.)
4. Sensor part fixed to 12th fin from pipe fitting side
5. Holding part fixed to 13th fin from pipe fitting side
6. Pipe fitting
S6RW0C7216010
2
I7RW01721018-01
1
5
6
I7RW01721026-01
2
4
3
I6RW0C721007-01