Rear Disc Brake Caliper Inspection; Rear Brake Disc Removal And Installation - Suzuki 2006 SX4 Service Manual

4C-7 Rear Brakes:

Rear Disc Brake Caliper Inspection

Pin Boot and Cylinder Boot
Check boots (1) for breakage, crack and damage.
If defective, replace.
1
Disc Brake Piston
Check all around piston for rust, corrosion and any other
damage.
If it is found faulty, replace.
Caliper
Push in adjusting bolt (1) by hand and move lever to
check that adjusting bolt (1) moves smoothly in the
arrow direction.
Also, check adjusting bolt (1) for any damage. If it is
found faulty, replace.
S6RW0C4306006
1
1
I6RS0B431019-01
I6RS0B431020-01
1
I6RS0B431021-01
Slide Pin
Check guide pin for smooth movement as shown.
If it is found faulty, correct or replace.
Apply rubber grease to guide pin outer surface. Rubber
grease should be the one whose viscosity is less
affected by such low temperature as –40 °C (–40 °F).

Rear Brake Disc Removal and Installation

CAUTION
!
During removal, be careful not to damage
brake flexible hose and not to depress brake
pedal.
Removal
1) Hoist vehicle and remove wheel.
2) Remove brake caliper assembly referring to "Rear
Disc Brake Caliper Removal and Installation".
NOTE
Hang removed caliper with a wire hook or the
like so as to prevent brake hose from
bending and twisting excessively or being
pulled.
Don't operate brake pedal with brake pads
removed.
3) Pull brake disc off by using 8 mm bolts (1) (2 pcs).
I6RS0B431022-01
S6RW0C4306007
1
1
I7RW01432006-01