Suzuki 2006 SX4 Service Manual page 259

2) Check that match mark (1) on crankshaft timing
sprocket is in match with timing mark (2) on lower
crankcase.
3) Apply engine oil to idler sprocket shaft and bush of
idler sprocket (1).
4) Install idler sprocket and idler sprocket shaft.
5) Install 1st timing chain by aligning dark blue plate (4)
of 1st timing chain (3) and match mark (2) on idler
sprocket (1).
6) Bring gold plate (4) of 1st timing chain (3) into match
with match mark (2) on crankshaft timing sprocket
(1).
7) Apply engine oil to sliding surface of timing chain
tensioner (1) and then install it as shown in figure.
Tighten tensioner nut to specified torque.
Tightening torque
Timing chain tensioner nut (a): 25 N·m (2.5 kgf-
m, 18.0 lb-ft)
I2RH01140082-01
2. Spacer
8) With latch of tensioner adjuster No.1 returned and
plunger (1) pushed back into body, insert stopper (4)
into latch (2) and body (3).
After inserting it, check to make sure that plunger will
not come out.
I2RH01140084-01
9) Install timing chain tensioner adjuster No.1 (1).
Tightening torque
Timing chain tensioner adjuster No.1 bolt (a): 11
N·m (1.1 kgf-m, 8.0 lb-ft)
10) Pull out stopper (2) from timing chain tensioner
adjuster No.1.
I2RH01140085-01
Engine Mechanical: 1D-28
I2RH01140086-01
I2RH01140087-01
I7RW01140058-01