Suzuki 2006 SX4 Service Manual page 985

4. Individual circuit fuse box No.1
Troubleshooting
Step
1 Was "Air Bag Diagnostic System Check Flow" performed?
2 SDM power supply and ground circuit check
1) Check SDM power supply and ground circuit referring to
"SDM Power Supply and Ground Circuit Check".
Is SDM power supply and ground circuit in good condition?
3 "AIR BAG" warning light circuit check
1) Disconnect combination meter connector "G241"
referring to "Combination Meter Removal and Installation
in Section 9C".
2) Disconnect SDM connector "L04".
3) Check for proper connection to SDM connector at
terminal "L04-2".
4) Check for proper connection to combination meter at
terminal "G241-5".
5) If OK, measure resistance between "G241-5" and "L04-
2" terminals.
Special tool
(A): 09932–76010
"L04-2"
"G241-5"
Is measured resistance 1
4 "AIR BAG" warning light circuit check
1) Measure resistance between "L04-2" terminal and body
ground.
Special tool
(A): 09932–76010
"L04-2"
Is measured resistance infinity?
8. "A/B" fuse
Action
(A)
I7RW01822006-01
Ω
or less?
(A)
I7RW01822007-01
12. "AIR BAG" warning light
Yes
Go to Step 2.
Go to Step 3.
Go to Step 4.
Go to Step 5.
Air Bag System: 8B-20
No
Go to "Air Bag
Diagnostic System
Check Flow".
Repair defective power
supply and ground
circuit.
Repair "YEL/BLK" wire
(between combination
meter and SDM
connector) for open or
high resistance.
Repair "YEL/BLK" wire
(between combination
meter and SDM
connector) for short to
ground.