Suzuki 2006 SX4 Service Manual page 1058

8B-93 Air Bag System:
Disabling Air Bag System
1) Turn steering wheel so that vehicle's wheels (front
tires) are pointing straight ahead.
2) Disconnect negative (–) cable at battery.
3) Turn ignition switch to "LOCK" position and remove
key.
4) Remove "A/B" fuse from junction block assembly.
5) Remove driver side front pillar lower trim and
disconnect yellow connector (1) for driver air bag as
follows.
a) Release locking of lock slider (2).
b) After unlocked, disconnect connector.
6) Remove passenger side front pillar lower trim and
disconnect yellow connector (3) for passenger air
bag as follows.
a) Release locking of lock slider (2).
b) After unlocked, disconnect connector.
1
3
7) Side-air bag (inflator) model:
Disconnect yellow connector of side-air bag (inflator)
module under front seat cushion (1).
a) Release locking of lock slider (2).
b) After unlocked, disconnect connector.
2
a)
b)
Repair Instructions
S6RW0C8206001
a)
b)
2
I7RW01821012-01
1
I6RW0B820017-01
8) Side curtain-air bag (inflator) model:
Remove quarter inner trim and disconnect yellow
connector (1) of side curtain-air bag (inflator)
module.
a) Release locking of lock slider (2).
b) After unlocked, disconnect connector.
NOTE
With "A/B" fuse removed and ignition switch
ON, "AIR BAG" warning light will be ON.
This is normal operation and does not
indicate air bag system malfunction.
Enabling Air Bag System
1) Confirm that battery negative (–) cable is
disconnected.
2) Turn ignition switch to "LOCK" position and remove
key.
3) Connect yellow connector (1) of driver air bag
(inflator) module by pushing connector till click is
heard from it.
4) Connect yellow connector (1) of passenger air bag
(inflator) module by pushing connector till click is
heard from it.
1
S6RW0C8206002
1
I5RW0A820091-01
I5RW0A820062-02