Suzuki 2006 SX4 Service Manual page 705

3) Using special tool and hydraulic press (2), compress
underdrive clutch piston return spring (1) until spring
seat is pushed down to 1 – 2 mm (0.039 – 0.078 in.)
lower than snap ring groove and install snap ring (3).
Special tool
(A): 09926–98350
NOTE
• When installing return spring, be careful
so that return spring will not fall or tilt.
• Do not align opening in snap ring with lug
of underdrive clutch piston return spring at
its retainer section.
CAUTION
!
Be careful when applying pressure, for
overpressure will cause plate section of
underdrive clutch piston return spring to
deform.
1
3
4) Install cushion plate "C", separate plates "S", friction
5) Install snap ring (1).
2
(A)
6) Measure underdrive clutch piston stroke again, using
I4RH01510143-01
Automatic Transmission/Transaxle:
plates "F" and retaining plate "R" of coast clutch in
the following order.
C → S → F → S → F → S → F → R
NOTE
Make sure that "A" section of cushion plate
faces toward piston side.
NOTE
Make sure that opening end of ring is not
aligned with groove section of drum.
R
1
S
F
C
A
special tools.
If measured piston stroke exceeds specified value,
replace underdrive clutch retaining plate with new
one so that piston stroke is within standard value.
Special tool
(A): 09900–20607
(B): 09900–20701
Overdrive clutch piston stroke
Standard: 1.22 – 1.69 mm (0.048 – 0.067 in.)
Available underdrive clutch retaining plate
thickness
3.6 mm (0.141 in.), 3.8 mm (0.150 in.), 4.0 mm
(0.158 in.)
3
1. Transaxle rear cover
2. Overdrive / coast clutch assembly
3. Underdrive clutch piston
5A-117
1
I7RW01510056-01
(B)
(A)
1
2
I4RH01510147-01