Dtc Clearance; Dtc Table - Suzuki 2006 SX4 Service Manual

DTC Clearance

1) Turn ignition switch to OFF position.
2) Connect SUZUKI scan tool to data link connector
(DLC) (1) located on underside of instrument panel
at driver's seat side.
Special tool
(A): SUZUKI scan tool
(A)
1

DTC Table

CAUTION
!
Be sure to perform the "EPS System Check" before starting troubleshooting corresponding to each
DTC.
DTC
Detecting item
No.
No
Normal
CODES
Steering torque sensor
C1111 (Main) circuit voltage
Steering torque sensor
(Main and Sub) circuit
C1113
correlation
Steering torque sensor
C1115 (Sub) circuit voltage
Steering torque sensor
C1116 power supply circuit
S6RW0C6304004
I5RW0A630004-01
Detecting condition
(DTC will set when detecting)
—
Circuit voltage of sensor main is
more than 4.5 V or less than 0.5
V
Difference between steering
torque calucurated based on
sensor main signal and steering
torque calucurated based on
sensor sub signal is more than
4.9 N⋅m
or
Difference between
instantaneous value and average
value of steering torque
calculated based on sensor main
signal and steering torque
calculated based on sensor sub
signal is more than 2.94 N⋅m
Circuit voltage of sensor sub
signal is more than 4.5 V or less
than 0.5 V
Circuit voltage of torque sensor 9
V power supply is less than 7 V
Power Assisted Steering System:
3) Turn ignition switch to ON position.
4) Erase DTC according to the instructions displayed
on SUZUKI scan tool. For further details, refer to
operator's manual for SUZUKI scan tool.
5) After completing the clearance, turn ignition switch to
OFF position and disconnect SUZUKI scan tool from
DLC.
Trouble area
—
• Torque sensor signal
circuit
• Torque sensor
• P/S control module
• Torque sensor 9 V
power supply circuit
• Torque sensor
• P/S control module
6C-9
S6RW0C6304005
"EPS"
DTC warning
light
— —
1 driving 1 driving
cycle cycle
1 driving 1 driving
cycle cycle
1 driving 1 driving
cycle cycle
1 driving 1 driving
cycle cycle