Sdm Removal And Installation - Suzuki 2006 SX4 Service Manual

5) Install driver and passenger side front pillar lower
trim.
6) Side-air bag (inflator) model:
Connect yellow connector (1) of side-air bag
(inflator) module by pushing connector till click is
heard from it.
7) Side curtain-air bag (inflator) model:
Connect yellow connector (1) of side curtain-air bag
(inflator) module by pushing connector till click is
heard from it.
1
8) Install right-side rear quarter lower trim.
9) Install "A/B" fuse to fuse box.
10) Connect negative (–) cable at battery.
11) Turn ignition switch to ON position and verify that
"AIR BAG" warning light flashes 6 times and then
turns OFF. If it does not operate as described,
perform "Air Bag Diagnostic System Check".

SDM Removal and Installation

WARNING
!
During service procedures, be very careful
when handling a Sensing and Diagnostic
Module (SDM).
Be sure to read "Precautions on Service and
Diagnosis of Air Bag System" before starting
to work and observe every precaution during
work. Neglecting them may result in personal
injury or inactivation of the air bag system
when necessary.
Removal
1) Disconnect negative (–) cable at battery.
2) Disable air bag system referring to "Disabling Air
Bag System".
3) Remove console box referring to "Console Box
Components in Section 9H".
4) Remove G sensor referring to "G Sensor Removal
and Installation (4WD Model) in Section 4E" and its
bracket (1).
1
I5JB0A820070-01
5) Disconnect SDM connector (1) from SDM (2).
6) Remove SDM (2) from vehicle.
I5RW0A820063-01
S6RW0C8206003
Air Bag System:
1
2. SDM
A
2
1
A: Forward
8B-94
2
I5RW0A820064-01
I4RS0A820056-01