Dtc P0962: Pressure Control Solenoid "A" Control Circuit Low - Suzuki Grand Vitara 2011 Manual

5A-61 Automatic Transmission/Transaxle:
DTC Troubleshooting
Step
1 Was "A/T System Check" performed?
2 Check shift solenoid valve–B for operation referring to
"Solenoid Valves (Shift Solenoid-A, Shift Solenoid-B, TCC
Pressure Control Solenoid and Pressure Control Solenoid
Inspection".
Are they in good condition?

DTC P0962: Pressure Control Solenoid "A" Control Circuit Low

Wiring Diagram
1. Pressure control solenoid valve
DTC Detecting Condition and Trouble Area
DTC Detecting Condition
Pressure control solenoid valve output voltage is too low
comparing with TCM command value.
(1 driving cycle detection logic)
DTC Confirmation Procedure
1) Connect scan tool to DLC with ignition switch OFF.
2) Clear DTCs in TCM and ECM memories by using scan tool.
3) Start engine.
4) Keep engine running at idle speed for 30 seconds or more.
5) Check DTC, pending DTC and freeze-frame data.
Action
12V
E92-4 YEL/RED
BRN/RED
E92-2
E92
6 5
4 3 2 1
16 15 14 13 12 11 10 9 8 7
24 23 22 21 20 19 18 17
2. TCM
Yes
Go to Step 2.
Clean fluid passage or
replace valve body
assembly.
2
1
E93
6 5 4 3 2 1
17 16 15 14 13 12 11 10 9 8 7
21 20 19 18
26 25 24 23 22
3. Terminal arrangement of TCM connector (viewed from harness side)
Trouble Area
• Pressure control solenoid valve circuit open or
shorted to ground.
• Malfunction of pressure control solenoid valve.
• TCM
No
Go to "A/T System
Check".
Replace shift solenoid
valve–B.
S6JB0A5104034
3
I5JB0A510024-01