Sdram Data Upload (Sp5-824) (B044/B045/B046) - Gestetner B130 Service Manual

Rev.11/2004
SDRAM Data Upload/Download B044/B045/B046 Models
Before installing a new FCU, and before executing a "memory all clear," you should
upload all current SRAM data into a flash memory card. You can then download
the data back after completing the FCU replacement or memory clear.
• SP5-824: Upload from the machine's SRAM to a flash memory card.
• SP5-825: Download from a flash memory card to the machine's SRAM
SRAM Data Upload (SP5-824)
NOTE: 1) Be sure to turn off the main switch before inserting or removing the flash
memory card. Installing or removing a card while the main switch is on
may damage the FCU.
2) This operation will erase any data already stored in the flash memory
card.
1. Turn off the main switch.
2. Insert the flash memory card [A] into the card slot, with the card's "B" side
facing the rear of the machine.
3. Turn on the main switch.
4. Access SP 5-824.
5. Enter "1" at the keypad, and then press OK or
6. The machine erases the card, and then saves its SRAM data into it. The "ON"
lamp flashes, and the screen counts down the progress. Uploading takes about
30 seconds. On successful completion, the screen displays "Loading
completed."
NOTE: If uploading fails, the "Loading error!!!" message appears. If this occurs,
try repeating the procedure.
7. Turn off the main switch, then remove the memory card.
Display during upload:
[A]: "10" = erasing card
"11" = saving to card
[B]: Amount (bytes) remaining
SM
CÓPIA NÃO CONTROLADA
SRAM Data Upload
11
5-93
CÓPIA NÃO CONTROLADA
SERVICE PROGRAM
B046I125.WMF
: 120834
[B]
[A]
B129 Series/B044 Series