Gestetner B130 Service Manual page 55

For the B044/B045/B046 Models: Use steps 22-24. Then proceed to step 25.
22. Install the DF connection board [A] and DF board bracket [B]. (
[C]
23. Connect the four wire sets from the DF body to CN103, CN105, CN106, and
CN107 on the DF connection board. (Not shown in illustration.)
24. Connect one end of the supplied wire harness [C] to CN101 and CN102 on the
DF connection board, and connect the other end to connectors CN9 and CN10
on the FCU. Secure the wire harness into the clamp [D] located to the side of
the DF board.
25. Reassemble the whole copier.
26. Plug in the power cord, and turn on the main switch.
27. Make a full-size copy from the paper tray using the ADF, and check the leading
edge registration. Adjust the registration as necessary. (Registration
adjustment procedures are located in Section 3 "Replacement and Adjustment"
of this Service Manual.)
SM
CÓPIA NÃO CONTROLADA
DOCUMENT FEEDER (B696 AND B444)
[D]
[ B ]
1-27
CÓPIA NÃO CONTROLADA
x 5)
[A]
B046I513.WMF
B129 Series/B044 Series