Firmware Update Procedure For Mfp Machines - Gestetner B130 Service Manual

FIRMWARE UPDATE PROCEDURE (B130/B168/B169)

5.2.3 FIRMWARE UPDATE PROCEDURE FOR MFP MACHINES

The following is the revised procedure for firmware update on the MFP model using
an SD card.
Before beginning the following, first confirm which firmware version(s) are currently
installed in the machine with SP7-801-255.Then print the list from SP5-990-005
(retain this printout for reference).
1. Turn off the main power switch.
2. IMPORTANT: Physically disconnect the
copier from the network and fax lines (if
IEEE 1394, USB, IEEE 802.11b, or
Bluetooth are installed, remove them
from the machine).This prevents jobs
from coming into the copier during
firmware update.
3. Remove the slot cover [A] (
4. Turn the label on the SD card [B] to the
rear side of the copier, and insert the
SD card into the lower slot [C]. Slowly
push the SD card into the slot so it locks
in place.
5. Make sure the SD card is locked in place.
NOTE: To remove the SD, push it in to unlock the spring lock and then release it
so it pops out of the slot.
6. Turn the main power switch on.
• After about 5 seconds, the LCD will display "Please wait..." Then, about 60
seconds later, the LCD will display "Program UpDate Menu P.01" on the first
line and the name of the firmware on the second line (e.g. Engine).
B129 Series/B044 Series
CÓPIA NÃO CONTROLADA
x 1)
5-106
CÓPIA NÃO CONTROLADA
[C]
[A]
[B]
B130S902.WMF
SM