Gestetner B130 Service Manual page 638

Switch 03
No. FUNCTION
4 V.8 protocol
0: Off
1: Disabled
5 Compression modes available
in transmit mode
0: MH only
1: Disabled
6 ECM during transmission
7 Bit 7 Bit 6 Setting
0 0 Off
0 1 On
1 0 Not used
1 1 Disabled
Switch 04: Not used (do not change any of these settings)
Switch 05: Not used (do not change any of these settings)
Switch 06: Not used (do not change any of these settings)
Switch 07: Not used (do not change any of these settings)
Switch 08: Not used (do not change any of these settings)
Switch 09: Not used (do not change any of these settings)
SM
CÓPIA NÃO CONTROLADA
DEDICATED TRANSMISSION PARAMETERS
If transmissions to a specific destination always end
at a lower modem rate (14,400 bps or lower),
disable V.8 protocol so as not to use V.34 protocol.
0: V.34 communication will not be possible.
If the setting is 'Disabled', the bit switch setting is
used.
This bit determines the capabilities that are informed
to the other terminal during transmission.
If the setting is 'Disabled', the bit switch setting is
used.
For example, if ECM is switched on but is not
wanted when sending to a particular terminal, use
the (0, 0) setting.
Note that V.8/V.34 protocol and JBIG compression
are automatically disabled if ECM is disabled.
If the setting is 'Disabled', the bit switch setting is
used.
5-45
CÓPIA NÃO CONTROLADA
COMMENTS
B465