Gestetner B130 Service Manual page 251

FIRMWARE UPDATE PROCEDURE (B130/B168/B169)
If an error occurs, the error code is
displayed. For information on the
error codes, see the table below.
Code
E20 Physical address mapping error
E22 Decompression error
E23 Update program error
E24 SD card access error
E31 Download data inconsistency*
E32 Download data inconsistency*
E33 Version data error
E34 Locale data error
E35 Machine model data error
E36 Module data error
E40 Engine program error**
E42 Operation panel program error*
E44 Controller program error*
⇒
E50 Authentication error
*
You must reinstall the program.
Try pressing the "1", "4", "3", keys on the operation panel when the error
appears then press the clear key
If the firmware update program is interrupted, for example by power failure,
keep the SD card inserted and turn the main switch off and on. The firmware
update program restarts. If you do not do so, the message "Reboot after Card
insert" is displayed when you turn the main switch on.
B129 Series/B044 Series
CÓPIA NÃO CONTROLADA
FIRMWARE ERROR CODE TABLE
Cause
• Insert the SD card correctly.
• Use another SD card
• Store correct data in the SD card.
• Update controller program.
• Replace the controller.
• Insert the SD card correctly.
• Use another SD card.
• Insert the SD card that is used when the previous
update procedure is interrupted.
• Insert the SD card that stores the correct data.
• Store the correct data in the SD card.
• Store the correct data in the SD card.
• Store the correct data in the SD card.
• Store the correct data in the SD card.
• Store the correct data in the SD card.
• Replace BICU.
• Store the correct data in the SD card.
• Replace the operation panel board.
• Store the correct data in the SD card.
• Replace the controller board.
• Write Protect switch on SD Card is set ON.
• Store the correct data in the SD card
three times.
CÓPIA NÃO CONTROLADA
Necessary Action
5-110
Rev. 12/2005
SM