Gestetner B130 Service Manual page 220

7
Mode Number/Name
825 Total Counter Reset
1
901 SC History Display
1
902 SC History Reset
1
908 PCU Counter Display
1
909 PCU Counter Reset
1
911* ID Sensor Error Counter Display
1
912 ID Sensor Error Counter Reset
1
SM
CÓPIA NÃO CONTROLADA
Resets the electronic total counter.
[0 = No / 1 = Yes]
•
This reset is generally performed at installation. This
SP mode is effective only once, while the counter still
has a negative value. This SP cannot be used once the
counter takes a positive value.
•
After selecting "1", hold down the Original Type key
and press the OK key (or
the reset is successful, the display shows "Action
completed." If the reset fails, the display shows "Error!!!".
Displays the codes of the last fifty errors that have
occurred.
[0 = No / 1 = Yes]
On fax-equipped models, you can print out the last fifty
error codes using fax service mode 04. For information,
refer to the fax service manual.
Clears the SC history.
[0 = No / 1 = Yes]
•
Note that when executed on fax-equipped models,
this operation will not clear the machine's service-report
data.
•
After selecting "1", hold down the Original Type key
and press the OK key (or
the reset is successful, the display shows "Action
completed." If the reset fails, the display shows "Error!!!".
Displays the number of prints made since the PCU was
last replaced.
Resets the developer counter.
[0 = No / 1 = Yes]
After selecting "1", press the Original Type key and the
OK key (or key) at the same time to execute the reset.
If the reset is successful, the display shows "Action
completed." If the reset fails, the display shows "Error!!!".
Displays the total number of logged ID sensor errors.
For information about how to analyze these errors, see
Section 5.1.11.
Resets the ID sensor error counter.
[0 = No / 1 = Yes]
After selecting "1", hold down the Original Type key and
press the OK key (or
reset is successful, the display shows "Action completed."
If the reset fails, the display shows "Error!!!".
5-79
CÓPIA NÃO CONTROLADA
SERVICE PROGRAM
Function/[Setting]
key) to execute the reset. If
key) to execute the reset. If
key) to execute the reset. If the
B129 Series/B044 Series