Gestetner B130 Service Manual page 630

Address
40144E Minimum pause between dialed
digits (pulse dial mode)
40144F Time waited when a pause is
entered at the operation panel
401450 DTMF tone on time
401451 DTMF tone off time
401452 Tone attenuation level of DTMF
signals while dialing
401453 Tone attenuation value difference
between high frequency tone and
low frequency tone in DTMF signals
401454 PSTN: DTMF tone attenuation level
after dialling
401455 ISDN: DTMF tone attenuation level
after dialling
401456 Not used
401457 Time between 40144Dh (NCU
parameter 14) and 40144Eh (NCU
parameter 15)
401458 Not used
401459 Grounding time (ground start mode)
40145A Break time (flash start mode)
40145B International dial access code (High)
40145C International dial access code (Low)
40145D PSTN access pause time
40145E Progress tone detection level, and
cadence detection enable flags
40145F Not used
to
401464
SM
CÓPIA NÃO CONTROLADA
Function
5-37
CÓPIA NÃO CONTROLADA
NCU PARAMETERS
Unit Remarks
20 ms See Notes 3 and 7.
Function 07-0 (parameter
15).
Function 07-0 (parameter
16). See Note 7
1 ms Function 07-0 (parameter
17). See Note 7
Function 07-0 (parameter
18). See Note 7
-dBm x 0.5 Function 07-0 (parameter
19).
See Note 5 and 7.
-dBm x 0.5 Function 07-0 (parameter
20).
The setting must be less
than –5dBm, and should
not exceed the setting at
401452h above.
See Notes 5 and 7.
-dBm x 0.5 Function 07-0 (parameter
21). See Note 5.
-dBm x 0.5 See Note 5
Do not change the setting.
1 ms
Do not change the setting.
20 ms The Gs relay is closed for
this interval.
1 ms The OHDI relay is open
for this interval.
BCD For a code of 100:
40145B - F1
40145C - 00
20 ms This time is waited for
each pause input after
the PSTN access code. If
this address contains
FF[H], the pause time
stored in address 40144F
is used.
In the UK: Do not set a
number higher than 7.
Bits 7–3: Not used
Bits 2–0: See Note 2.
Do not change these settings.
B465