Selecting Programs; Specifying Values; Activating Copy Mode - Gestetner B130 Service Manual

SERVICE PROGRAM
Starting SSP Mode
NOTE: The SSP mode is not available in the B129 (the machine without the
controller box).
1. Type the keys as follows:
2. Press the key and hold it down until the SP-mode menu is displayed (about
3 seconds).
3. Press the key and hold it down.
4. While holding down the
5. While holding down the

Selecting Programs

• When a blinking underscore (or several blinking underscores) is displayed, you
can type a number from the numeric keypad [D].
• When the sign "
through the menu by pressing the left-arrow key [B] or the right-arrow key [C]. To
select a program, press the OK key [F].

Specifying Values

1. After locating a program, press the OK key. A blinking underscore (or several
blinking underscores) indicates which value you can change. The value in
parentheses is the default value of the menu.
2. Type a necessary value from the numeric keypad. To switch between positive
(plus) and negative (minus) values, press the
3. To validate the value, press the OK key. To cancel the value, press the cancel
key [E].

Activating Copy Mode

You can activate the copy mode while the SP mode is running. When you do so,
the copier outputs images or patterns that help you adjust the SP setting.
1. Press the key. The copy mode is activated.
2. Specify copy settings and press the
3. To return to the SP mode, press the
NOTE: You cannot end the SP mode while the copy mode is activated.
Quitting Programs/Ending (S)SP Mode
Press the key or the cancel key to quit the program. You can end the SP
mode by pressing one of these keys several times.
B129 Series/B044 Series
CÓPIA NÃO CONTROLADA
→
key, press the
key, press the "OK" key.
/OK" [A] is displayed upper right corner, you can scroll
5-2
CÓPIA NÃO CONTROLADA
→ →
key (on the numeric keypad).
key.
key.
key.
SM