Gestetner B130 Service Manual page 154

SP5-XXX (Mode)
5001 All Indicators On
5001 1 Turns on all LEDs. The LCD turns on or off every 3 seconds. Press the reset key to
end this program.
5113* Optional Counter Type
5113 1 Selects the corresponding key for installed devices such as coin lock.
5120* Clear-OP Count Remove
5120 1 Specifies the condition to reset the copy job settings when the key counter is
removed.
• 0 = Yes: The settings are cleared when the counter is removed.
• 1 = Standby only: The settings are cleared when the counter is removed at the
end of a job.
• 2 = No: The settings are not cleared under either condition.
As for duplex copying, the job settings are always preserved regardless of these
setting.
5121* Count Up Timing
5121 1 Selects the count-up timing.
• 0 = Feed: At each paper feed
• 1= Exit: At each paper exit
5501* PM Alarm Interval
5501 1 Printout
5501 2 On/Off
5801 Memory Clear (basic model only)
5801 2 Engine 5.1.5
5802 Machine Free Run
5802 1 Conducts machine free run (including the scanner unit). Press "ON" to start; press
"OFF" to stop.
5803 Input Check
5.1.6
5804 Output Check
5.1.7
SM
CÓPIA NÃO CONTROLADA
0: None
11: MF key card (Increment)
12: MF key card (Decrement)
[0=Yes / 1=Standby only / 2=No]
[0 = Feed In / 1 = Exit]
[0 ~ 9999 / 0 / 0K copies/step]
Specifies when the PM alarm occurs.
Enables/disables the PM alarm for the total number
of prints, copies, and faxes. [0 =Disable / 1 =Enable]
5-13
CÓPIA NÃO CONTROLADA
SERVICE PROGRAM
B129 Series/B044 Series