Gestetner B130 Service Manual page 211

SERVICE PROGRAM
4
Mode Number/Name
932* Auto Density Adjustment
933* Blank-Page Sensor Level Adjustment
934* Peak Setting
935* AE Tracking Speed
936* Peak Offset Select
961* Plotter Mode Select
962* Marking Image Density Conversion
963* Marking Image Density Setting
964* Spot Dot Enhancement Select
B129 Series/B044 Series
CÓPIA NÃO CONTROLADA
[-2 ~ 2 / 0 / 1/step] DFU (Not effective on this machine.)
[-2 ~ 2 / 0 / 1] DFU (Not effective on this machine.)
Sets adjustment the machine will use when setting white
peak prior to start of scanning, for the mode selected by
SP4-921.
[–128 ~ 127 / 0 / 1/step]
•
If AE tracking is enabled, the applied peak becomes:
[(detected peak + this setting) x approx. 40%]
•
If AE tracking is disabled, the applied peak becomes:
[(detected peak + this setting)
Adjusts the white-peak tracking speed for the mode
selected by SP4-921.
[–2 ~ 2 / 0 / 1/step]
Negative settings reduce the speed; positive settings
increase it.
Sets the peak correction offset for the mode selected by
SP4-921.
[–2 ~ 2 / 0 / 1/step] IP
Negative settings produce better reproduction of low-contrast originals.
Positive settings provide better elimination of dirty background.
Selects the plotter mode used by the processing mode
selected by SP4-921. IP
[0 = Selected processing mode's default /
1 = Normal (no correction) / 2 = Toner save /
3 = FCI
•
The default varies according to the processing mode
selected by SP4-241
Selects the image density conversion for the processing
mode selected by SP4-921.
[–2 ~ 2 / 0 / 1/step] IP
A setting of "0" sets conversion OFF. Negative settings
reduce the black marking size, while positive values
magnify it.
Sets the density adjustment type for the mode selected by
SP4-921. IP
[0 ~ 5 / 0 / 1/step], where:
0: The mode's default value is used.
1: Distortion prevention
2: Distortion prevention and edge correction
3: Normal
4: Light edge correction
5: Dense edge correction
5-70
CÓPIA NÃO CONTROLADA
Function/[Setting]
SM