Gestetner B130 Service Manual page 35

5. Remove the three scanner lock
pins. (A tag is hanging from each
pin.) To remove: Grasp the base
of the pin [A], turn the pin 90
degrees, and pull it down and out.
6. Remove the tags from the pins.
7. Break each pin off the base [A].
8. Discard the pin part [B].
9. Set each base [A] back into its original hole, turning it 90° to lock it into place.
(Be sure to do this for all three pins.)
10. When installing a DF-equipped
model
(B046/B129/B130/B168/B169),
raise the DF upper guide [C] and
remove the protective paper [D] at
the feed unit. Then lower the guide.
11. Open the platen cover [E] (or DF, if
equipped) and remove the
protective paper [F] covering the
exposure glass. Then close the
platen cover/DF.
SM
CÓPIA NÃO CONTROLADA
[C]
[D]
B046I107.WMF
1-7
CÓPIA NÃO CONTROLADA
COPIER
B046I106.WMF
[E]
[F]
B129 Series/B044 Series
[B]
[A]