Gestetner B130 Service Manual page 631

NCU PARAMETERS
Address
401465 Long distance call prefix (HIGH)
401466 Long distance call prefix (LOW)
401467 Not used
to
401468
401469 Distinctive ring
40146A Distinctive ring minimum off time
40146B Distinctive ring maximum one cycle
time
40146C Not used
to
401471
Acceptable ringing signal frequency:
401472
range 1, upper limit
401473 Acceptable ringing signal frequency:
range 1, lower limit
401474 Acceptable ringing signal frequency:
range 2, upper limit
401475 Acceptable ringing signal frequency:
range 2, lower limit
401476 Number or rings until a call is
detected
401477 Minimum required length of the first
ring
401478 Minimum required length of the
second and subsequent rings
401479 Ringing signal detection reset time
(LOW)
40147A Ringing signal detection reset time
(HIGH)
40147B Not used
to
401480
401481 Interval between dialing the last digit
and switching the Oh relay over to
the external telephone when dialing
from the operation panel in handset
mode.
B465
CÓPIA NÃO CONTROLADA
Function
5-38
CÓPIA NÃO CONTROLADA
Unit
BCD For a code of 0:
401465 - FF
401466 - F0
BCD
Do not change these settings.
Hex 00(H): OFF, 01(H): ON
1 ms
20 ms
±
20 ms
Do not change these settings.
Function 07-0
1000/ N (Hz)
(parameter 02).
See Note 7.
Function 07-0 (parameter
03).
See Note 7.
1000/ N (Hz) Function 07-0 (parameter
04).
See Note 7.
Function 07-0 (parameter
05).
See Note 7.
1 Function 07-0 (parameter
06).
The setting must not be
zero.
See Note 7.
20 ms See Note 4 and 7.
Function 07-0 (parameter
07).
20 ms Function 07-0 (parameter
08).
See Note 7.
20 ms Function 07-0 (parameter
09).
See Note 7.
20 ms Function 07-0 (parameter
10).
See Note 7.
Do not change the settings.
20 ms Factory setting: 500 ms
Remarks
SM