FAX UNIT
26. Do the following to confirm that the fax unit is correctly installed. If results are
incorrect, go back and repeat the installation procedure.
1) Access SP5-992 and select "2" to print out a full SMC report. Confirm that
the report shows a "YES" for SP7-801-3.
2) Press the On Hook key on the fax operation panel, and confirm that you
hear a dial tone coming from the monitor speaker.
27. Turn the power off, and then insert the memory card that you used at Step 2 to
save the old FCU's SRAM data.
28. Turn the power on, and run SP5-825 to download the saved data from the card
into the new FCU. (For instructions, see Section 5.1.8 of the base copier's
service manual.)
29. Turn the power off, remove the memory card, and turn the power back on.
30. Program the items required for fax communication, as indicated in section 1.2.3
Initial Programming.
B465
CÓPIA NÃO CONTROLADA
1-8
CÓPIA NÃO CONTROLADA
SM