Dedicated Transmission Parameters; Programming Procedure - Gestetner B130 Service Manual

DEDICATED TRANSMISSION PARAMETERS

5.4 DEDICATED TRANSMISSION PARAMETERS
Each Quick Dial Key and Speed Dial Code has eight bytes of programmable
parameters allocated to it. If transmissions to a particular machine often experience
problems, store that terminal's fax number as a Quick Dial or Speed Dial, and
adjust the parameters allocated to that number.
The programming procedure will be explained first. Then, the eight bytes will be
described.

5.4.1 PROGRAMMING PROCEDURE

⇒
1. Set bit 3 of System Bit Switch 04 to 1.
2. Either use the programming Quick Dial number or Speed Dial number.
Example: Change the Parameters in Quick Dial 01.
3. Make sure the machine is in standby mode. Press 'User Tools' key then
choose '2. Fax Features'.
4. Select the "1. Program/Delete", then press "OK" key.
Select "1. Prog. Quick dial" then press "OK" key.
Press Quick Dial key 01 and "OK" key.
5. Press the "OK" key three times.
6. The settings for byte 0 are now displayed. Press a number from 0 to 7
corresponding to the bit that you wish to change.
Example: Change bit 7 to 1: Press 7
7. To scroll through the parameter bytes, either:
Select the next byte:
or
Select the previous byte:
step 6.
8. After the setting is changed, press "OK" until "Programmed" displays.
9. To finish, press 'User Tools'.
B465
CÓPIA NÃO CONTROLADA
until the correct byte is displayed. Then go back to
5-42
CÓPIA NÃO CONTROLADA
Rev. 04/2005
SM