Gestetner B130 Service Manual page 174

SP5-XXX (Mode)
5001 All Indicators On
5001 1 Turns on all LEDs.
SSP Operation Panel Bit Switch DFU
5044*
5113* Optional Counter Type
5113 1 Selects the corresponding key for installed devices such as coin lock.
Clear-OP Count Remove
5120*
5120 1 Specifies the condition to reset the copy job settings when the key counter is
removed.
• 0 = Yes: The settings are cleared when the counter is removed.
• 1 = Standby only: The settings are cleared when the counter is removed at the
end of a job.
• 2 = No: The settings are not cleared under either condition.
As for duplex copying, the job settings are always preserved regardless of these
setting.
5121* Count Up Timing
5121 1 Selects the count-up timing.
• 0 = Feed: At each paper feed
• 1= Exit: At each paper exit
5162* Application Switching Method
5162 1 Determines whether the application screen is switched with the hardware switch or
the software switch.
5302* Time
5302 2 Time Difference
5307* Summer Time
5307 1 On/Off
5307 3 Start ( 5.1.13)
5307 4 End ( 5.1.13)
SM
CÓPIA NÃO CONTROLADA
0: None
5: MF key card (Peace) Japan Only
11: MF key card (Increment)
12: MF key card (Decrement)
[0=Yes / 1=Standby only / 2=No]
[0 = Feed In / 1 = Exit]
[0 = Soft Key Set / 1 = Hard Key Set]
[-1440 ∼ +1440 / -300 / 1 minute/step]
Species the time difference from GMT.
Validates or invalidates the daylight-saving-time
settings (SP5-307-003 and 004). OFF=0 ON=1
Specifies the start of the daylight saving time.
Specifies the end of the daylight saving time.
5-33
CÓPIA NÃO CONTROLADA
SERVICE PROGRAM
B129 Series/B044 Series