Gestetner B130 Service Manual page 396

System Switch 15
No FUNCTION
0 Not used
1 Going into the Energy Saver
mode automatically
0: Enabled
1: Disabled
2-3 Not used
4-5 Wait time for post message
00: 1 minute
01: 30 minutes
10: 1 hour
11: 24 hours
6 Shows user codes on reports
and lists
0: Disabled
1: Enabled
7 Not used
System Switch 16 - Not used (Do not change the settings.)
System Switch 17 - Not used (Do not change the settings.)
System Switch 18 - Not used (Do not change the settings.)
System Switch 19
No FUNCTION
0-2 Not used
3 Selects a temporary address
for the number PC-FAX #.
4
Number of jobs controlled for
PC-FAX TX
0: 64 Jobs
1: No limitations (but
conforms to device
limitations)
5-6 Not used
7 Special original mode
0: Disabled
1: Enabled
SM
CÓPIA NÃO CONTROLADA
Do not change the setting.
1: The machine will restart from the Energy Saver
mode quickly, because the +5V power supply is
active even in the Energy Saver mode.
Do not change the settings.
The machine stays in the standby mode for the
specified time if it reserves a post message in
memory.
The user codes are printed on reports and lists. The
default setting is "Disabled" since the user codes
used for authentication should not be seen.
Do not change the settings.
Do not change the settings.
0: When prefixed by #, handled only as a stored
address.
1: When prefixed by #, when a digit exists that
prevents handling the transaction as a Quick,
Speed, or Group dialing, handles temporarily.
Sets the number of jobs controlled for PC-FAX
transactions. If "1" is selected (no limitations), control
is relinquished to the device (standard 400,
expandable to 800).
Do not change the settings.
Enables the user to select the special original mode
from the operation panel. When the user selects this
mode, the text-mode LED and the photo-mode LED
light at the same time.
25
CÓPIA NÃO CONTROLADA
BIT SWITCHES
SP No. 1-101-022
COMMENTS
SP No. 1-101-026
COMMENTS
Fax Unit