Program Download - Gestetner B130 Service Manual

3. Hold down the Operation Switch and turn on the main switch.
NOTE: If the card does not contain a valid program, the machine will not start.
4. The machine boots from the card, automatically enters SP5-827, and displays
the following.

Program Download

(1:1st 2:2nd)
5. If you wish to load the program stored in first half of the card (in card space
000000h to 1FFFFFh), enter "1". If you wish to load the program stored in
second half of the card (space 200000h to 3FFFFFh), enter "2". Then press OK
to start the download.
NOTE: If you enter "0" (the default) instead of "1" or "2", the machine moves
back to the top-level SP5-827 screen. If you enter "1" or "2" but the
corresponding card space does not contain a valid program, the
machine displays "Loading error!!!".
6. The machine erases the current firmware, then begins downloading the new
firmware from the card. The "ON" lamp flashes, and the screen counts down
the progress. The download takes about 3 minutes.
NOTE: If downloading fails, the "Loading error!!!" message appears. If this
occurs, try repeating the procedure.
7. After completing the download, turn off the main switch and remove the
memory card.
8. Turn the switch back on, and run SP5-837 to check the checksums for the new
firmware. Then run SP7-801-1 to confirm that it correctly displays the new
firmware version.
NOTE: Be sure to remove the card and turn the main switch off and back on
before running the above SPs.
Display during download:
[C]: "0" = erasing flash ROM
"1" or "2" = writing to flash ROM
("1" if you selected "1st";
"2" if you selected "2nd".)
[D]: Amount (bytes) remaining
to be written
SM
CÓPIA NÃO CONTROLADA
B046M004.WMF
Program Download
5-97
CÓPIA NÃO CONTROLADA
SERVICE PROGRAM
0
1 : 2089024
[A] [B]
B129 Series/B044 Series
B046M006.WMF