Gestetner B130 Service Manual page 642

4000CC(H) - User parameter switch 12 (SWusr_0C)
Bit 0: Not used
Bit 1: Distinctive Ring detection (NA only)
Bit 2: Toner saving mode
Bits 3 to 7: Not used
4000CD(H) - User parameter switch 13 (SWusr_0D)
Bits 0 and 1: PSTN access method from behind a PABX
Bit 1 0 Setting
0 0 PSTN
0 1 Loop start (prefix)
1 0 Ground start
1 1 Flash start
Bits 2 to 7: Not used
4000CE(H) to 4000D8 - User parameter switch 14 to 24 (SWusr_0E to 18)
Bits 0 to 7: Not used
4000D9(H) - User parameter switch 25 (SWusr_19)
Bits 0 to 3: Not used
Bit 4: RDS operation
Bits 5 and 6: Not used
Bit 7: Daylight saving time (User tools)
4000DA(H) - User parameter switch 26 (SWusr_1A)
Bit 0 and 1: Dialing type
(This switch is not printed on the user parameter list.)
Bit 1 0 Setting
0 0 Pulse dialing (10 pps)
0 1 Pulse dialing (20 pps)
1 0 Tone (DTMF) dialing
Bits 2 to 7: Not used
4000DB(H) - User parameter switch 27 (SWusr_1B)
PSTN access code from behind a PABX (Key operator tools)
(This switch is not printed on the user parameter list.)
Access number
0
!
➨
9
00
!
➨
99
SM
CÓPIA NÃO CONTROLADA
0: Not acceptable
1: Acceptable for the limit specified by system switch 03
Note: This bit is only effective when RDS operation can be
selected by the user (system switch 02 bits 6 and 7).
Hex value to program (BCD)
F0
!
F9
00
!
99
5-49
CÓPIA NÃO CONTROLADA
SERVICE RAM ADDRESSES
0: Off, 1: On
0: Disabled, 1: Enabled
0: Disabled, 1: Enabled
B465