Gestetner B130 Service Manual page 108

CONTROLLER BOX AND BICU (B129/B130/B168/B169)
NOTE: 1) When replacing the controller board,
remove the NVRAM [A] from the old
controller board. Install the NVRAM to
the new controller board.
2) Do not change the dip switch settings.
4. Ground plate [B] (
5. BICU [C] (all
x 6)
NOTE: The B129 has an NVRAM
on the BICU. When
replacing the BICU,
remove the NVRAM [D]
from the board. Install the
NVRAM to the new board.
6. When you have replaced the NVRAM, copy the saved data to the NVRAM.
• From a memory card to the NVRAM (
• From an SD card to the NVRAM (
B129 Series/B044 Series
CÓPIA NÃO CONTROLADA
x 2)
's, 2 flat cables,
CÓPIA NÃO CONTROLADA
[C]
B130R920.WMF
5.1.9)
5.2.3)
3-32
Rev. 11/2004
[A]
B130R942.WMF
[B]
[D]
SM