Gestetner B130 Service Manual page 393

BIT SWITCHES
System Switch 09
No FUNCTION
0 Not used
1
Inclusion of communications on
the Journal when no image
data was exchanged.
0: Disabled 1: Enabled
2 Automatic error report printout
0: Disabled 1: Enabled
3 Printing of the error code on the
error report
0: No 1: Yes
4 Not used
5 Power failure report
0: Disabled 1: Enabled
6 Conditions for printing the
protocol dump list
0: Print for all communications
1: Print only when there is a
communication error
7 Priority given to various types
of remote terminal ID when
printing reports
0: RTI > CSI > Dial label > Tel.
number
1: Dial label > Tel. number >
RTI > CSI
System Switch 0A
No FUNCTION
0-3 Not used
4 Dialing on the ten-key pad
when the external telephone is
off-hook
0: Disabled 1: Enabled
5 On hook dial
0: Disabled 1: Enabled
6-7 Not used
Fax Unit
CÓPIA NÃO CONTROLADA
Do not change the setting.
0: Communications that reached phase C (message
tx/rx) of the T.30 protocol are listed on the Journal.
1: Communications that reached phase A (call
setup) of T.30 protocol are listed on the Journal.
This will include telephone calls.
0: Error reports will not be printed.
1: Error reports will be printed automatically after
failed communications.
1: Error codes are printed on the error reports.
Do not change the setting.
1: A power failure report will be automatically printed
after the power is switched on if a fax message
disappeared from the memory when the power was
turned off last.
This switch becomes effective only when system
switch 00 bit 6 is set to 1.
1: Set this bit to 1 when you wish to print a protocol
dump list only for communications with errors.
This bit determines which set of priorities the
machine uses when listing remote terminal names
on reports.
Dial Label: The name stored, by the user, for the
Quick/Speed Dial number.
Do not change the settings.
0: Prevents dialing from the ten-key pad while the
external telephone is off-hook. Use this setting when
the external telephone is not by the machine, or if a
wireless telephone is connected as an external
telephone.
1: The user can dial on the machine's ten-key pad
when the handset is off-hook.
0: On hook dial is disabled.
Do not change the settings.
22
CÓPIA NÃO CONTROLADA
SP No. 1-101-010
COMMENTS
SP No. 1-101-011
COMMENTS
SM