Installation Procedure - Gestetner B130 Service Manual

1.4.2 INSTALLATION PROCEDURE

CAUTION
Unplug the main machine's power cord before starting the following
procedure.
1. Remove the paper tray unit from the copier if it is already installed.
2. Remove the paper trays from the copier and from the paper tray unit.
3. Remove the ground screw [A] at the
rear of the paper tray unit.
4. Fasten the heater [B] and the supplied
ground wire [C] to the paper tray unit
( x 3). Note that [A] is the ground
screw you removed in the previous
step and [D] and [E] are the two
supplied heater fastening screws.
NOTE: Be sure to position the ground
wire [C] and heater harness
[F] so that they are out of the
way of the copier when you
set it onto the paper tray unit.
5. Set the copier onto the paper tray unit.
6. Screw the paper tray unit into place
using three supplied PTU fastening
screws.
SM
CÓPIA NÃO CONTROLADA
[B]
1-17
CÓPIA NÃO CONTROLADA
PAPER TRAY UNIT HEATER
[C]
[D]
[F]
[E]
B129 Series/B044 Series
[A]
B046I519.WMF
B046I500.WMF