Plotter Switches - Gestetner B130 Service Manual

5.1.3 PLOTTER SWITCHES

Plotter Switch 00
No. FUNCTION
0 Page separation mark
0: Disabled
1: Enabled
1 Repetition of data when the
received page is longer than
the printer paper
0: Disabled 1: Enabled
2–7 Not used
Plotter Switch 01
No. FUNCTION
0 Reset the fusing unit failure
0: Off
1: On (Clear)
1–7 Not used
Plotter Switch 02 - Not used (do not change any of these settings)
Plotter Switch 03
No. FUNCTION
0 Length reduction of received
data
0: Disabled 1: Enabled
1–3 Not used
SM
CÓPIA NÃO CONTROLADA
0: No marks are printed.
1: If a received page has to be printed out on two
sheets, an asterisk inside square brackets is printed
at the bottom right hand corner of the first sheet,
and a "2" inside a small box is printed at the top right
hand corner of the second sheet. This helps the
user to identify pages that have been split.
0: The next page continues from where the previous
page left off.
1: The final 10 mm of the previous page are
repeated at the top of the next page.
Do not change these settings.
When a fusing error occurs, set this bit to 1 after
fixing the problem. The machine then resets the
fusing error. Switch the machine off/on and this bit
will reset itself to 0.
Do not change these settings.
0: Incoming pages are printed without length
reduction.
(Page separation threshold: Plotter Switch 03, bits 4
to 7)
1: Incoming page length is reduced when printing.
(Maximum reducible length: Plotter Switches 04, bits
0 to 4)
Do not change these settings.
5-17
CÓPIA NÃO CONTROLADA
BIT SWITCHES
COMMENTS
COMMENTS
COMMENTS
B465