Scanner Alignment Adjustment - Gestetner B130 Service Manual

SCANNER UNIT

3.4.6 SCANNER ALIGNMENT ADJUSTMENT

1. Rear cover (
2. Rear scale, upper right cover, front left
cover, fax operation panel, operation
panel ( 3.3.5)
3. Exposure glass (
4. Loosen the 2 screws holding the 1st
and 2nd scanner belts in place.
5. Slide the 1st and 2nd scanners so that all four of the following are roughly
aligned on both the front and back sides:
• The hole on the copier's lid
• The hole on the 1st scanner
• The corner right hole on the 2nd scanner
• The hole at the base of the scanner
6. Insert the two optics adjustment tools
[A], and adjust the scanners as
necessary so that the tools go
through all four holes.
7. Tighten the two screws that you
loosened at step 2 above, so that the
belts are firmly clamped into place.
8. Remove the adjustment tools.
B129 Series/B044 Series
CÓPIA NÃO CONTROLADA
3.3.2)
3.4.1).
CÓPIA NÃO CONTROLADA
[A]
3-12
B130R948.WMF
B130R949.WMF
SM