Gestetner B130 Service Manual page 128

Table of Contents

Advertisement

SERVICE CALL CONDITIONS
No.
Definition
867
B
SD card access error 1
The SD card is removed from the slot
during operation.
868
B
SD card access error 2
An error is detected in the SD card.
870
C
Address book data error
An error is detected in the address
book data.
871
C
Flash ROM error
An error is detected in the address
book stored in the flash ROM.
900
B
Electrical total counter error
The electrical total counter contains
incorrect data.
901
B
Mechanical total counter error
The polling module does not detect the
mechanical total counter.
903
B
Engine total counter error
The checksum of the total counter is
not correct.
920
C
Printer error
A fatal error is detected in the printer
application program
921
C
Printer font error
Necessary font files are not found in the
SD card.
925
C
Net file error
The net-file management-file contains a
fatal error.
928
B
Memory error
An error occurs during the memory
check conducted when the main power
switch is turned on or when the copier
is recovering from the energy saver
mode.
929
B
IMAC hardware error
A memory control job is not completed
within a certain period.
B129 Series/B044 Series
CÓPIA NÃO CONTROLADA
Symptom
4-8
CÓPIA NÃO CONTROLADA
Possible Cause
• Loose connection
• /Bluetooth SD card
• /Bluetooth SD controller
• Data corruption
• Defective firmware
• Defective flash ROM device
• Defective flash ROM
• Defective NVRAM on the controller
• Defective mechanical total counter
• Defective BICU
• Loose connection
• Defective NVRAM on the BICU
• Defective printer application program
• Incorrect hardware configuration
(including memory shortage)
• Necessary font files not installed
• Data corruption
• Defective controller
• Data corruption
• Defective firmware
• Defective controller
• Defective memory
• Defective BICU
• Loose connection between the BICU
and the memory
• Check all connections on the BICU
• Check any harness on the BICU
connectors for damage
• Replace BICU for basic model (B129)
• Replace GW Controller for MFP and
FAX models (B130, B168)
Rev. 12/2005
SM

Advertisement

Table of Contents
loading

This manual is also suitable for:

B129B045B168B169B046B044

Table of Contents