Gestetner B130 Service Manual page 250

10. Turn the main power switch
"OFF" and "ON."
• The LCD will display "Please
wait..." for about 60 seconds,
after which it will return to the
"Program UpDate Menu"
screen.
11. Turn the main power switch off.
• Confirm the firmware version again by accessing SP 7-801-255 to display
firmware and SP 5-990-005 to print firmware versions. Compare the new
printout to the one obtained before the upgrade to verify the firmware changes.
• If the "Please Wait..." display does not change over to "Program Update Menu
P.01," it is possible the firmware has not been saved to the card correctly
(e.g. files saved to the wrong folder). Please refer to the important note in this
section SD card preparation to verify if the firmware was saved to the card
correctly.
12. Repeat Steps 6 - 11 above until all firmware updates are complete.
13. Reinstall the network and fax connections.
SM
CÓPIA NÃO CONTROLADA
FIRMWARE UPDATE PROCEDURE (B130/B168/B169)
5-109
CÓPIA NÃO CONTROLADA
B129 Series/B044 Series