Gestetner B130 Service Manual page 407

BIT SWITCHES
Communication Switch 0B - Not used (Do not change the settings.)
Communication Switch 0C - Not used (Do not change the settings.)
Communication Switch 0D
No FUNCTION
0 The available memory
to threshold, below which ringing
7 detection (and therefore
reception into memory) is
disabled
Communication Switch 0E
No FUNCTION
0 Minimum interval between
to automatic dialing attempts
7
Communication Switch 0F - Not used (Do not change the settings.)
Communication Switch 10
No FUNCTION
0 Memory transmission:
to Maximum number of dialing
7 attempts to the same
destination
Communication Switch 11 - Not used (Do not change the settings.)
Communication Switch 12
No FUNCTION
0 Memory transmission: Interval
to between dialing attempts to the
7 same destination
Communication Switch 13 - Not used (Do not change the settings.)
Fax Unit
CÓPIA NÃO CONTROLADA
00 to FF (Hex), unit = 4 kbytes
(e.g., 06(H) = 24 kbytes)
One page is about 24 kbytes.
The machine refers to this setting before each fax
reception. If the amount of remaining memory is
below this threshold, the machine cannot receive
any fax messages.
If this setting is kept at 0, the machine will detect
ringing signals and go into receive mode even if
there is no memory available. This will result in
communication failure.
06 to FF (Hex), unit = 2 s
(e.g., 06(H) = 12 s)
This value is the minimum time that the machine
waits before it dials the next destination.
01 - FE (Hex) times
01 - FF (Hex) minutes
36
CÓPIA NÃO CONTROLADA
SP No. 1-104-014
COMMENTS
SP No. 1-104-015
COMMENTS
SP No. 1-104-017
COMMENTS
SP No. 1-104-019
COMMENTS
SM