Downloading Sd Card Data - Gestetner B130 Service Manual

FIRMWARE UPDATE PROCEDURE (B130/B168/B169)

Downloading SD Card Data

Data can also be copied from an SD card to the NVRAM.
1. Turn off the main power switch of the copier.
2. Insert the SD card into the lower slot. Ensure that the SD card is correctly set.
3. Turn on the main power switch of the copier.
4. Activate the SP mode.
5. Select SP5-825-001 (NVRAM Download).
6. Press the Execute key. The copier starts downloading.
If an error occurs, perform the following:
1. Check the serial number of the data. You can find the serial number in the file
name of the data. (See "Uploading NVRAM Data" procedure on previous
page.)
2. Retry the download procedure.
3. If downloading does not normally end, manually specify settings. See the SMC
report for the settings.
B129 Series/B044 Series
CÓPIA NÃO CONTROLADA
5-112
CÓPIA NÃO CONTROLADA
SM