Gestetner B130 Service Manual page 376

Code Meaning
0-07 No post-message response
from the other end after a
page was sent
0-08 The other end sent RTN or
PIN after receiving a page,
because there were too
many errors
0-14 Non-standard post message
response code received
0-15 The other terminal is not
capable of specific
functions.
0-16 CFR or FTT not detected
after modem training in
confidential or transfer mode
SM
CÓPIA NÃO CONTROLADA
Suggested Cause/Action
• Check the line connection.
• Replace the FCU.
• The other end may have jammed or run out of
paper.
• The other end user may have disconnected the
call.
• Check for a bad line.
• The other end may be defective; try sending to
another machine.
• Check the line connection.
• Replace the FCU.
• The other end may have jammed, or run out of
paper or memory space.
• Try adjusting the tx level and/or cable equalizer
settings.
• The other end may have a defective
modem/NCU/FCU; try sending to another
machine.
• Check for line problems and noise.
Cross reference
• Tx level - NCU Parameter 01 (PSTN)
• Cable equalizer - G3 Switch 07 (PSTN)
• Dedicated Tx parameters - Section 4
• Incompatible or defective remote terminal; try
sending to another machine.
• Noisy line: resend.
• Try adjusting the tx level and/or cable equalizer
settings.
• Replace the FCU.
Cross reference
• See error code 0-08.
The other terminal is not capable of accepting the
following functions, or the other terminal's memory
is full.
• Confidential rx
• Transfer function
• SEP/SUB/PWD/SID
• Check the line connection.
• Replace the FCU.
• Try adjusting the tx level and/or cable equalizer
settings.
• The other end may have disconnected, or it may
be defective; try calling another machine.
• If the rx signal level is too low, there may be a
line problem.
Cross reference
• See error code 0-08.
5
CÓPIA NÃO CONTROLADA
ERROR CODES
Fax Unit