Gestetner B130 Service Manual page 48

PAPER TRAY UNIT HEATER
15. Pass the heater harness through the
hole [B] at the rear of the copier.
16. Pass relay harness [C] through the
opening [D] (at the rear of the PSU)
and through the other opening [B].
17. Connect the relay harness to the
heater's harness [E].
18. Pull the relay harness back into
the copier.
19. Attach the ferrite core [A] over the
relay harness.
20. Push the ferrite core back so that
it is over the heater's harness.
21. Wrap the heater's harness once
around the ferrite core [B].
22. Locate the ferrite core at the rear of
the copier [A] behind the rear clamp.
23. Secure the ferrite core with the
supplied tie wrap [C].
24. Clip off the excess length of the tie wrap [D].
25. Connect the relay harness connector [E] to the large connector at the front
center of the PSU.
26. Screw the ground wire [F] to the PSU bracket with the included grounding
screw.
27. Attach the clamps [G] to the PSU bracket.
28. Attach the heater harness though the clamps.
29. Position the harness so that the front clamp is between the two bindings [H] on
the harness.
30. Fasten the clamps.
B129 Series/B044 Series
CÓPIA NÃO CONTROLADA
[B]
[C]
[D]
1-20
CÓPIA NÃO CONTROLADA
[E]
[B]
[A]
[G]
[E]
[C]
[D]
B046I520.WMF
[H]
[F]
B046I521.WMF
SM