Gestetner B130 Service Manual page 225

SERVICE PROGRAM
Executing Memory Clear on B129
1. Upload the NVRAM data to a flash memory card (
2. Print out all SMC data lists (
NOTE: Be sure to print out all the lists. You have to manually change the SP
settings if the NVRAM data upload ends abnormally.
3. Select SP5-801-002.
4. Press the OK key.
5. Select "Execute." The messages "Execute?" followed by "Cancel" and
"Execute" are displayed.
6. Select "Execute."
7. When the program has ended normally, the message "Completed" is displayed.
If the program has ended abnormally, an error message is displayed.
8. Press the cancel key.
9. Turn the main switch off and on.
10. Download the NVRAM data from a flash memory card (
Executing Memory Clear on B130/B168/B169
1. Print out all SMC data lists (
2. Select SP5-801-002 (B129) or SP5-998-001 (B130/B168/B169).
NOTE: SP5-998-001 clears the memory on the BICU. SP5-801-001 clears the
memory on the controller.
3. Press the OK key.
4. Select "Execute." The messages "Execute?" followed by "Cancel" and
"Execute" are displayed.
5. Select "Execute."
6. When the program has ended normally, the message "Completed" is displayed.
If the program has ended abnormally, an error message is displayed.
7. Turn the main switch off and on.
8. Adjust the printer and scanner registration and magnification (
9. Refer to the SMC lists, and enter any values that differ from the factory
settings. Double-check the values for SP4-901.
10. Adjust the standard white level (SP4-428).
11. Initialize the TD sensor (SP 2-214).
12. Check the copy quality.
B129 Series/B044 Series
CÓPIA NÃO CONTROLADA
5.1.12).
5.1.12).
5-84
CÓPIA NÃO CONTROLADA
Rev. 11/2004
5.1.9).
5.1.9).
3.14).
SM