Parameters - Gestetner B130 Service Manual

5.4.2 PARAMETERS

The initial settings of the following parameters are all FF(H)—all the parameters
are disabled.
Switch 00
FUNCTION AND COMMENTS
ITU-T T1 time (for PSTN G3 mode)
If the connection time to a particular terminal is longer than the NCU parameter setting,
adjust this byte. The T1 time is the value stored in this byte (in hex code), multiplied by 1
second.
Range:
0 to 120 s (00h to 78h)
FFh - The local NCU parameter factory setting is used.
Do not program a value between 79h and FEh.
Switch 01
No. FUNCTION
0–4 Tx level
Bit 4 3 2 1 0
0 0 0 0 0
0 0 0 0 1
0 0 0 1 0
0 0 0 1 1
0 0 1 0 0
:
:
0 1 1 1 1
1 1 1 1 1 Disabled
5–7 Cable equalizer
Bit 7 6 5 Setting
0 0 0 None
0 0 1 Low
0 1 0 Medium
0 1 1 High
1 1 1 Disabled
SM
CÓPIA NÃO CONTROLADA
DEDICATED TRANSMISSION PARAMETERS
If communication with a particular remote terminal
Setting often contains errors, the signal level may be
0 inappropriate. Adjust the Tx level for
-1 communications with that terminal until the results
-2 are better.
-3
-4
If the setting is 'Disabled', the NCU parameter 01
setting is used.
-15
Note: Do not use settings other than listed on the
left.
Use a higher setting if there is signal loss at higher
frequencies because of the length of wire between
the modem and the telephone exchange when
calling the number stored in this Quick/Speed Dial.
Also, try using the cable equalizer if one or more of
the following symptoms occurs.
•
Communication error with error codes such as
0-20, 0-23, etc.
•
Modem rate fallback occurs frequently.
If the setting is 'Disabled', the bit switch setting is
used.
Note: Do not use settings other than listed on the
left.
5-43
CÓPIA NÃO CONTROLADA
COMMENTS
B465