Gestetner B130 Service Manual page 209

SERVICE PROGRAM
4
Mode Number/Name
902* Exposure Lamp ON
908 SBU Auto-Adjustment
1
913* DF Shading Interval Time
1
921* Image Adjustment Selection
1
B129 Series/B044 Series
CÓPIA NÃO CONTROLADA
Lets you turn the exposure lamp on and off.
[0 = Lamp Off / 1 = Lamp On]
•
To turn the exposure lamp on, press "1". To turn the
lamp off, press "0". To exit, press
•
The scanner moves to the shading position and
remains there until you exit the SP.
•
The display also shows the minimum and maximum
white-plate values (updated every 0.5 sec.).
Performs auto scanner adjustment.
[0 = No (normal operation) / 1 = Yes (start adjustment)]
•
Use this SP after replacing the white plate, FCU, or
lens block, and after executing a Memory All Clear (SP5-
801).
•
( IAJ, "Standard White Density Adjustment".)
Adjusts the interval used for shading processing in DF
mode.
[0 ~ 255 / 30 / 1s/step]
•
Setting this value to 255 will switch off auto-shading
between pages of DF copy jobs.
•
Light and heat may affect scanner response. Reduce
this setting if copy quality indicates that the white level is
drifting during DF copy jobs.
Use this to select the processing mode (pattern) that you
wish to set adjustment parameters for. After selecting the
mode, you can set the adjustment parameters for that
mode using SPs 4-922 to 4-966. IP
There are 11 modes ("Pattern 1" to "Pattern 11"), as
follows.
1 = Text 1
2 = Text 2
3 = Photo 1
4 = Photo 2
5 = Special 1
6 = Special 2
First use the right or left cursor key to select the mode
["Pattern 1" to "Pattern 11"], and then press "1" to enable
adjustment for that mode. Then press OK, and then
proceed to use SPs 4-922 to 4-966 to make adjustments.
•
If you press "0" and then press OK, SPs 4-922 to 4-
966 will not operate.
5-68
CÓPIA NÃO CONTROLADA
Function/[Setting]
or Cancel to exit.
7 = Special 3
8 = Fax Text 1 ("text sharp")
9 = Fax Photo 1 "(photo smooth")
10 = Fax Photo 2 ("photo normal")
11 = Fax Text 2 ("text dropout")
SM