Gestetner B130 Service Manual page 618

Communication Switch 14
No. FUNCTION
5 Not used
6, 7 Available unit of resolution in
which fax messages are
received
Bit 7 Bit 6
0 0
0 1
1 0
inch
1 1
Communication Switch 15
No. FUNCTION
0, 1 Available resolution for
receiving fax messages
Bit 0 1: 200 x 100/8 x 3.85
Bit 1 1: 200 x 200/8 x 7.7
Other bits: Not used
2–7 Not used
Communication Switch 16 - Not used (do not change any of these settings)
Communication Switch 17 - Not used (do not change any of these settings)
Communication Switch 18 - Not used (do not change any of these settings)
Communication Switch 19 - Not used (do not change any of these settings)
Communication Switch 1A - Not used (do not change any of these settings)
Communication Switch 1B
No. FUNCTION
0 Extension access code (0 to
7) to turn V.8 protocol On/Off
1
0: On 1: Off
2
3
4
5
6
7
SM
CÓPIA NÃO CONTROLADA
Do not change the setting.
For the best performance, do not change the factory
settings.
Unit The setting determined by these bits is informed to
mm the transmitting terminal in the pre-message
inch
protocol exchange (in the DIS/NSF frames).
mm and
(default)
Not used
For the best performance, do not change the factory
settings.
The setting determined by these bits is informed to
the transmitting terminal in the pre-message
protocol exchange (in the DIS/NSF frames).
Do not change these settings.
If the PABX does not support V.8/V.34 protocol
procedure, set one of these bits to "1" to disable V.8.
Example: If "0" is the PSTN access code, set bit 0
to 1. When the machine detects "0" as the first
dialed number, it automatically disables V.8
protocol. (Alternatively, if "3" is the PSTN access
code, set bit 3 to 1.)
5-25
CÓPIA NÃO CONTROLADA
BIT SWITCHES
COMMENTS
COMMENTS
COMMENTS
B465