C-Rp - 3Com 5500G-EI Command Reference Manual

264 C 7: U M
HAPTER SING

c-rp

P C
ULTICAST ROTOCOL OMMANDS
Parameter
interface-type interface-number
router. The candidate BSR is configured on the interface. PIM-SM must be enabled
on the interface first.
hash-mask-len:
Priority of the candidate BSR. The larger the value of the priority, the
priority :
higher the priority of the BSR. The value ranges from 0 to 255. The default value is
0.
Description
Use the to configure a candidate BSR.
c-bsr
Use the
undo c-bsr
By default, no candidate BSR is set.
Related command:
Example
Configure the Ethernet Switch as C-BSR with priority 2 (and the C-BSR address is
designated as the IP address of VLAN-interface10).
<SW5500>system-view
System View: return to User View with Ctrl+Z
[SW5500]multicast routing-enable
[SW5500] pim
[SW5500-pim]c-bsr vlan-interface 10 24 2
Syntax
c-rp interface-type interface-number
priority-value
priority
interface-type interface-number
undo c-rp {
View
PIM View
Parameter
interface-type interface-number:
advertised as a candidate RP address.
Number of the basic ACL that defines a group range, which is the
acl-number :
service range of the advertised RP. The value ranges from 2000 to 2999.
priority-value
default, it is 0. The greatest value corresponds to the lowest priority level.
Remove all candidate RP configurations.
all:
Description
Use the to configure the router to advertise itself as a candidate RP.
c-rp
:
Length of the mask. The value ranges from 0 to 32.
to remove the candidate BSR configured.
pim sm.
]*
Priority value of candidate RP, in the range of 0 to 255. By
:
Interface type and interface number of a
[ group-policy
| all }
Specified interface with the IP address
acl-number |